Pilz PSENvip RL D P Manual de usuario descargar pdf (Pagina 47)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

4-19

4.4 Description of the units

4 Function description

System status

Funktion_Display_OSSD

Status of the OSSD

Funktion_Display_Betriebszustand_P_Variante

Operating state

Funktion_D isplay_Eingabefeld

Status Description

SYSTEM OK The PSENvip is performing the specified operating mode

without error, see table: "Operating status"

TEST The PSENvip is performing calibration and internal tests.

STANDBY The PSENvip is deactivated when the press is in setup

mode.

ERROR An error has occurred (HOLD, STOP, FATAL). See

Chapter 9, "Diagnostics and Troubleshooting"

Status Description

OSSD ON The output signal switching devices OSSD1 and OSSD2

are in the ON state.

The protected field is clear.

OSSD OFF The output signal switching devices OSSD1 and OSSD2

are in the OFF state.

The protected field is interrupted. Or the PSENvip is not in

the status: SYSTEM OK or NORMAL OPERATION

State Description

NORMAL OP-

ERATION

One of the protected field modes is activated.

See Chapter 8, "Operation"

SETUP This is the operating mode in which you enter the overrun.

See Chapter 7, "Commissioning"

TOOL CHANGE This is the operating mode in which you track the adjust-

ment line to the tip of the tool during a tool change.

See Chapter 7, "Commissioning"

ADJUSTMENT This is the operating mode in which you set up the trans-

mitter and receiver mechanically so that they are calibrated

with each other.

See Chapter 7, "Commissioning"

DIAGNOSTICS System data and error codes are displayed in this menu.

Pilz technical support can use these to locate errors.

See Chapter 9, "Diagnostics and Troubleshooting"

MENU On pressing the <MODE> key, you can choose between

the following

options:

- TOOL CHANGE: Adjustment during tool change

- ADJUSTMENT: Adjustment during initial commissioning

- DIAGNOSTICS: Display error codes

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 138 139

Comentarios a estos manuales

Sin comentarios

Pilz PSENvip RL D P Manual de usuario Pagina 47

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Pilz PSENvip RL D P