Pilz PSENvip RL D P Manual de usuario descargar pdf (Pagina 106)

7.5 Check protective equipment

7 Commissioning

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

7-24

Fig. 7-21: Function test using test rod

The test rod must be detected along the whole length of the detection

zone.

The OSSDs switch to the OFF state. The LED on the receiver lights up

red.

Function test with 10 mm and 15 mm test piece

 Position the 10 mm high section of the test piece on top of the lower

tool.

 Initiate a press stroke.

Fig. 7-22: Function test using test piece

INFORMATION

The following tests must be run on the left- and right-hand end

as well as in the centre of the press brake:

- During initial commissioning: 10 times

- During the daily check and during a tool change: 3 times

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 138 139

Sin comentarios

Pilz PSENvip RL D P Manual de usuario Pagina 106