Pilz PSENvip RL D P Manual de usuario descargar pdf (Pagina 18)

3.1 Intended use

3 Safety

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

3-2

3.1.1 Approvals

Approvals3-Sicherheit_Zulassungen

3.1.2 Safety during operation

Safety during operation3-Sicherheit_Betrieb_Allg

Intended use also includes awareness of the hazards that arise during

operation, against which the PSENvip does not provide protection.

3.1.2.1 Hazards arising from the installation of the PSENvip

Hazards arising from the installation of the PSENvip3-Sicherheit_Betrieb_Montage

When installing the PSENvip, please note the following:

 The PSENvip must be installed so that there are no crushing or shear-

ing hazards between the moving transmitter/receiver and the fixed

machine parts or any other parts around the machine.

 If hazard areas cannot be avoided, other safeguards must be put in

place.

3.1.2.2 Hazards arising from a reduced protected field

Hazards arising from a reduced protected field3-Sicherheit_Betrieb_Schutzfeld_reduziert

The full protected field is only active in standard protected field mode.

In box bending or box bending with back gauge protected field mode,

the protected field is reduced. This means there can only be limited pro-

tection against trapping and crushing. The protected field is around the

tolerance zone behind the bending line. Any parts of the body within the

danger zone will only be detected behind the bending line. There is a risk

of injury from trapping or crushing.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 138 139

Sin comentarios

Pilz PSENvip RL D P Manual de usuario Pagina 18