Pilz PSSu H DN Manual de usuario descargar pdf (Pagina 21)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

6-1

6.1 Interface configuration

6 Interfaces

66000InterfacesInterfaces6-6.1Interface configuration6100Interface configuration6-][Anschluss DN

 n.c. = not connected

6.1.1 Connection to DeviceNET

Connection to DeviceNET6-][BA_Verdrahtung DN

Please refer to the “DeviceNET Specification” from the Open DeviceNet

Vendor Association (ODVA).

The PSSu is connected to DeviceNET via a 5-pin Combicon plug-in con-

nector.

6.1.2 Connection via USB

Connection via USB6-][BA_Verdrahtung USB

Please note the requirements of the USB standard for USB 2.0 and for

Mini-B USB ports.

The maximum cable runs for USB connection cable are 5 m.

DeviceNet Layout

5-pin Combicon plug-in connector 1: V-

2: CAN_Low

3: Shield

4: CAN_High

5: V+

USB Layout

Mini-B USB connector 1: n.c.

2: D- USB Data –

3: D+ USB Data +

4: n.c.

5: GND Ground

INFORMATION

Earth the cable shield on the connector or as it enters the control

cabinet.

Signal lines on the first and last subscribers should use connec-

tors with terminating resistors in accordance with the “Device-

NET Specification”, Vol. 1 Chapter 9, with 121 Ohm, 1% metal

film, 50 mW.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Sin comentarios

Pilz PSSu H DN Manual de usuario Pagina 21